.

First layer acceleration 500.

This might make those inconsistencies a lot less noticeable. As shown in the images, certain sections of the layer are decent while there are almost seemingly periodic points in the layer where it seems to be too low.

If you purchase using a shopping link, we may earn a commission.

I am getting these big bulges at the same point (across z-axis) across the whole.

First Layer printing speed 20. Stabilize Z axis rods. .

&92;endgroup.

. I bought an Ender 3 v2 in January 2021 for my second printer. .

. .

48.

.

I have been having issues on my Ender 3 v2 for a while regarding the first layer. .

At one point, there may be less filament flowing out, and at another point, there may be more. .

I have had an Ender 3 for two years and love the quality it prints.
.
.

If things are working properly, these layers will appear to be a single, smooth surface.

At one point, there may be less filament flowing out, and at another point, there may be more.

Printing PLA at 205 &176;C. Increase Infill Line Width Try a 50 increase and run a test print. inconsistent layers in some models.

No first-layer fan (or any cooling at any point) I've tried Increasing initial Z-offset; this doesn't work since it. I have problems with layer widths and uneven outer walls on my 3D prints. Change the extrusion settings. Ender 3 (V2Pro) Layer Shift 6 Tips to Fix It. 0 C.

As you can see on the photo my print quality decreased significantly.

0. 3dsourced.

because you know.

Estep calibration- Done, set to 97.

.

1See more.

The Judges Introduction.